[pvrusb2] New driver snapshot: pvrusb2-mci-20100424

[devsk]

> Check the .config for your kernel and see if CONFIG_VIDEO_PVRUSB2_DVB 

Yeah, that's what guided me to try the command line that I tried afterwards.

-devsk





________________________________
From: Mike Isely <isely at isely.net>
To: Communications nexus for pvrusb2 driver <pvrusb2 at isely.net>
Sent: Sat, April 24, 2010 2:19:32 PM
Subject: Re: [pvrusb2] New driver snapshot: pvrusb2-mci-20100424

On Sat, 24 Apr 2010, devsk wrote:

> Never mind! I used the following to rebuild the module and it works now:
> 
> $ make INSTALL_MOD_DIR=pvrusb2 -C /lib/modules/2.6.33.2/build M=/private/shared/Installs/pvrusb2-mci-20100424/driver CONFIG_VIDEO_PVRUSB2=m CONFIG_VIDEO_PVRUSB2_24XXX=y CONFIG_VIDEO_PVRUSB2_SYSFS=y  CONFIG_VIDEO_PVRUSB2_DEBUGIFC=y CONFIG_VIDEO_ADV_DEBUG=y modules
> 
> And the garbage is gone! Have done few modprobe followed by modprobe -r. Looks good!
> 
> -devsk
> 

And that I believe will also have the same effect of disabling DVB 
support in the standalone driver, thus the unresolved references are 
removed.

Check the .config for your kernel and see if CONFIG_VIDEO_PVRUSB2_DVB 
was turned on there.  It might not be (which would explain why the 
in-kernel version of the driver is loading ok).

A "default" build of the standalone driver tries to turn everything on.  
It might be useful to only turn on what has actually been configured 
into the kernel you are compiling against, but I'm not sure if I can 
make that work.

  -Mike


-- 

Mike Isely
isely @ isely (dot) net
PGP: 03 54 43 4D 75 E5 CC 92 71 16 01 E2 B5 F5 C1 E8
_______________________________________________
pvrusb2 mailing list
pvrusb2 at isely.net
http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2