[pvrusb2] Poor analog picture on HVR-1950 after upgrade to 2.6.28 kernel

[fivenote]

Mike,

Sorry, but I didn't see this list of steps you asked for last night.
Do you still need me to do this? I think I've done 1-5, but not steps
6-8.

-vincent

On Fri, Jun 12, 2009 at 6:30 PM, Mike Isely<isely at isely.net> wrote:
>
> Vincent:
>
> I'd also like you to do the following:
>
> 0. Shut down mythtv backend (if running).
>
> 1. Power device off.
>
> 2. Wait about 2-3 seconds.
>
> 3. Power device on.
>
> 4. Wait about 5-7 seconds (to allow the driver to fully initialize so
> you can get the log messages).
>
> 5. Run dmesg, save to a file and send that to me.
>
> 6. Stream some video with mplayer, either composite input or an analog
> RF signal (if you can).
>
> 7. While streaming, do "cat /sys/class/pvrusb2/*/debuginfo".  Capture
> output, send to me.
>
> 8. Run dmesg again - you'll see a new block reporting "card status".
> This is an additional effect from cat'ing debuginfo (a log request is
> generated to all associated drivers).  Capture that block to a file and
> send it to me.
>
> That should be enough for me to figure out what state the hardware is
> getting into, either so I can solve it or at least be able to reproduce
> the behavior here.
>
>  -Mike
>
>
> --
>
> Mike Isely
> isely @ isely (dot) net
> PGP: 03 54 43 4D 75 E5 CC 92 71 16 01 E2 B5 F5 C1 E8
> _______________________________________________
> pvrusb2 mailing list
> pvrusb2 at isely.net
> http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
>



-- 
~~~~~~~~~~~~~~~~~~~~
VAO - fivenote at gmail.com
~~~~~~~~~~~~~~~~~~~~