[pvrusb2] Poor analog picture on HVR-1950 after upgrade to 2.6.28 kernel

[Scott Doty]

On 06/12/2009 03:30 PM, Mike Isely wrote:
> 6. Stream some video with mplayer, either composite input or an analog
> RF signal (if you can).
>
> 7. While streaming, do "cat /sys/class/pvrusb2/*/debuginfo".  Capture
> output, send to me.
>
> 8. Run dmesg again - you'll see a new block reporting "card status".
> This is an additional effect from cat'ing debuginfo (a log request is
> generated to all associated drivers).  Capture that block to a file and
> send it to me.
>
> That should be enough for me to figure out what state the hardware is
> getting into, either so I can solve it or at least be able to reproduce
> the behavior here.
>    

BTW, after doing all pending updates to my (newly-upgraded) f11 system, 
I was able to get good video from /dev/video0 -- only thing wrong was 
aspect ratio (looked to be 1:1)...

Also, when catting ...standard/cur_val, it used to say "none" before i'd 
set it to NTSC-M -- but this time, it said NTSC-M after boot, all I had 
to change in /sys was the input (to composite).

I'll still play with it, will try with vlc (which almost worked before, 
but showed up as pal, even when the standard was specifically set to 
NTSC)...

  -Scott
Linux eva.ponzo.net 2.6.29.4-167.fc11.x86_64 #1 SMP Wed May 27 17:27:08 
EDT 2009 x86_64 x86_64 x86_64 GNU/Linux

using stock driver, didn't have debug turned on.