[pvrusb2] pvr-usb2 not installing

[Travis]

 I am running a clean install of mythbuntu. I was using an internal pvr150
but the interference was to much, so I switched to a hauppauge pvr-usb2
29xxx. I have not been able to get it working. I installed the driver and
firmware following the directions here (
http://www.isely.net/pvrusb2/pvrusb2.html) and here (
http://www.isely.net/pipermail/pvrusb2/2006-October/001064.html).

When I plug in the pvr-usb2 my dmesg reads as following:

[  355.502334] usb 5-1: new high speed USB device using ehci_hcd and address
6
[  356.033603] usb 5-1: new high speed USB device using ehci_hcd and address
7
[  356.329207] usb 1-1: new full speed USB device using uhci_hcd and address
5
[  356.449035] usb 1-1: device descriptor read/64, error -71
[  356.672730] usb 1-1: device descriptor read/64, error -71
[  356.888433] usb 1-1: new full speed USB device using uhci_hcd and address
6
[  357.008277] usb 1-1: device descriptor read/64, error -71
[  357.231967] usb 1-1: device descriptor read/64, error -71
[  357.447672] usb 1-1: new full speed USB device using uhci_hcd and address
7
[  357.855110] usb 1-1: device not accepting address 7, error -71
[  357.966959] usb 1-1: new full speed USB device using uhci_hcd and address
8
[  358.374400] usb 1-1: device not accepting address 8, error -71

This has me stumped. A point in the right direction would be appreciated.

-- 
Travis



-- 
Travis