[pvrusb2] pvrusb2-mci-20070114 radio support - stereo?

[Rick Macdonald]

Mike Isely wrote:
> That dump is a mixture of ivtv and pvrusb2 related messages.  While we 
> can pick that apart, it'd be better just to run that 'cat 
> /sys/class/pvrusb2/*/debuginfo' command and THEN look at the log.

I was wondering if my setup is bothered by the internal PVR-150, so I
took an old laptop (450MHz) that has 2.6.15. I reconfigured the kernel,
installed mplayer and your latest driver, etc. It behaves exactly like
my desktop. The radio is mono but the sound changes a little when I
toggle ctl_audio_mode, but still mono. I could send you a recorded
example if you like.

Here is the dump in case it's useful. I do this while the radio is
playing. Is that right? The log has very little info. Is that because I
don't have ivtv installed? Should I? The radio and tv seem to work
without it on this laptop.

(sorry about the line wrap)

rickmvnote:~# cat /sys/class/pvrusb2/*/debuginfo
big lock free; ctl lock free
driver flags: initialized ok connected
Subsystems enabled / configured: +ENC_FIRMWARE +ENC_CFG +DIG_RUN
+USB_RUN +ENC_RUN
Subsystems disabled / unconfigured:
Attached I2C modules:
MSP3445G-B8 @ 0x40 (handler: pvrusb2-audio v4l1) [v4l1_standard
v4l1_volume v4l1_freq]
i2c IR (Hauppauge) @ 0x18 [v4l2_standard v4l2_audiomode v4l2_bcsh
v4l2_volume v4l2_freq v4l2_size v4l2_log]
Philips NTSC MK3 (FM1236MK3 or FM1236/F) @ 0x61 (handler: pvrusb2-tuner)
[v4l2_standard v4l2_audiomode v4l2_bcsh v4l2_volume v4l2_freq v4l2_size
v4l2_log]
tda9887 @ 0x43 (handler: pvrusb2-demod) [v4l2_standard v4l2_audiomode
v4l2_bcsh v4l2_volume v4l2_freq v4l2_size v4l2_log]
tveeprom @ 0x50 [v4l2_standard v4l2_audiomode v4l2_bcsh v4l2_volume
v4l2_freq v4l2_size v4l2_log]
saa7115 @ 0x21 (handler: pvrusb2-video-v4l (old routing)) [v4l2_standard
v4l2_audiomode v4l2_bcsh v4l2_volume v4l2_freq v4l2_size v4l2_log]


Jan 22 12:48:43 rickmvnote kernel: pvrusb2: =================  START
STATUS CARD #0  =================
Jan 22 12:48:43 rickmvnote kernel: tda9887 0-0043: Data bytes: b=0c c=90
e=1d
Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Audio frequency: 48 kHz
Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Video signal:    bad
Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Frequency:       60Hz
Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Detected format:
BW/No color
Jan 22 12:48:43 rickmvnote kernel: pvrusb2: ==================  END
STATUS CARD #0  ==================

Here is the log from bootup:

Jan 22 11:56:21 rickmvnote kernel: usbcore: registered new driver pvrusb2
Jan 22 11:56:21 rickmvnote kernel:
/usr/local/src/pvrusb2/pvrusb2-mci-20070121/driver/pvrusb2-main.c:
Hauppauge WinTV-PVR-USB2 MPEG2 Encoder/Tuner : 20070121 (from 
www.isely.net)
Jan 22 11:56:21 rickmvnote kernel:
/usr/local/src/pvrusb2/pvrusb2-mci-20070121/driver/pvrusb2-main.c: Debug
mask is 15 (0xf)
Jan 22 11:56:21 rickmvnote kernel: usb 1-1: reset full speed USB device
using uhci_hcd and address 2
Jan 22 11:56:21 rickmvnote kernel: msp3400 0-0040: chip=MSP3445G-B8
+nicam +simple +simpler +radio mode=simpler
Jan 22 11:56:21 rickmvnote kernel: msp3400 0-0040: msp34xxg daemon started
Jan 22 11:56:21 rickmvnote kernel: input: i2c IR (Hauppauge) as
/class/input/input4
Jan 22 11:56:21 rickmvnote kernel: tuner 0-0061: chip found @ 0xc2
(pvrusb2_a)
Jan 22 11:56:21 rickmvnote kernel: tda9887 0-0043: chip found @ 0x86
(pvrusb2_a)
Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: saa7115 found @ 0x42
(pvrusb2_a)
Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: Hauppauge model
29032, rev D158, serial# 7570160
Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: tuner model is
Philips FM1236 MK3 (idx 58, type 43)
Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: TV standards NTSC(M)
(eeprom 0x08)
Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: audio processor is
MSP3445 (idx 12)
Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: decoder processor is
SAA7115 (idx 19)
Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: has radio, has IR remote
Jan 22 11:56:21 rickmvnote kernel: tuner 0-0061: type set to 43 (Philips
NTSC MK3 (FM1236MK3 or FM1236/F))
Jan 22 11:56:21 rickmvnote kernel: Adding 377992k swap on /dev/hda2.
Priority:-1 extents:1 across:377992k
Jan 22 11:56:21 rickmvnote kernel: tda9887 0-0043: Data bytes: b=14 c=30
e=44
Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Audio frequency: 48 kHz
Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Video signal:    bad
Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Frequency:       60Hz
Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Detected format:
BW/No color
Jan 22 11:56:21 rickmvnote kernel: pvrusb2: Device initialization
completed successfully.
Jan 22 11:56:21 rickmvnote kernel: pvrusb2: registered device video0 [mpeg]
Jan 22 11:56:21 rickmvnote kernel: pvrusb2: registered device radio0 [mpeg]

...RickM...